Stringing GUN EZ-50 (10-50 MM)

Stringing GUN EZ-50 (10-50 MM)
for all electrical installations

conduits of int. Ø 13 to 50 mm
· also for flexible tubes
· through kinked conduits
· easy handling
· up to several hundred meters of pulling
· double function blowing and suction mode
· simple changing
· all commercial boxes
· forget all problems of cable pulling thanks to EZ-50
· variation of accessories

Intended Use :
· for blowing in a special pull line in all commercial conduits
· installations in the range of private, office and industrial buildings
· for all commercial boxes, junction boxes, sockets, lamp boxes etc.
(even with very tight clearance)
· problems with f.e. kinked conduits can be solved by changing to
suction mode, fix suction device and suck line on from opposite end

Function :
· apply line brake
· fit joint/nozzle appropriate to conduit diameter
· firstly blow through the conduit with air, check if penetrable tube/correct tube
· make either a loop or fix a pearl at pull line
· release line brake
· blow pull line in without interrupting, observe uncoiling in cylinder
· release switch and close nozzle with finger
· apply line brake and cut off pull line
· fix wire/s to the pull line and start pulling

Stringing Gun EZ-50
Standard equipment in strong plastic case
· 2 pull line rolls d 1 mm approx. 900 m
· Suction device
· 2 joints ½ with reducer 19/12 mm and nozzle Ø int. 9,5 mm
· 3 joints ¾ and nozzle Ø int. 16 mm plus nozzle Ø int. 19 mm
· 1 special nozzle black, for Ø int. from 25 to 50 mm
· 1 special nozzle with 90° angle, Ø ext. 12 mm (onl y with special nozzle black)
· 3 beads of Ø 11, 13 and 16 mm each